Broken spur gear?

[telluride201]

I was tightening the nut to the threads [blue] and I think I overdid it. A noticeable snap came from the spur gear, and then the shaft that holds all the parts could now spin with no trouble [red], letting me get stuck with my car half-assembled while lubricating. I was putting it back together and this happened. The small [steel?] pin is in it's right place. Do I need a new spur? Gotta get super-glue? Questions for extra details encouraged.

I posted the anatomy of the spur using Instagram you guys can look at. The link below brings you to it.

https://www.instagram.com/p/BPJSjEHhtjC/

I am a newbie so please don't be aggresive.

[jimbo74]

are you running a center diff?

[telluride201]

are you running a center diff?

I think the telluride only has one

[Slp2000gtp]

Mine doesn't spin. I've got mine apart now, unless that pin isn't in place there's no way it can spin. Only the bearing behind the parts in red. Not sure what happened there. Any upgrades to it? Motor wise?

[telluride201]

Mine doesn't spin. I've got mine apart now, unless that pin isn't in place there's no way it can spin. Only the bearing behind the parts in red. Not sure what happened there. Any upgrades to it? Motor wise?

Nah, it's all stock. I'll just continue reassembling it and post if there is a problem, or if I was just being ignorant. Most likely the latter.

[telluride201]

I was ignorant.

[Iansprouse1]

What I think happened is that the pin (red) fell out or broke of the blue area where the pin goes through the shaft and fits snugly in the slot (blue)


Sent from my iPhone using Tapatalk

[telluride201]

actually i didnt tighten the nut enough. thats all.

[jdpasl]

https://www.ebay.com/itm/Slipper-Clu...ss!70739!US!-1 Say goodbye to the slipper clutch. Awesomeness!

[Rain Dawg]

actually i didnt tighten the nut enough. thats all.

If your stuck for just the pin I always keep my broken or worn out drill bits in a box and find a bit that the shank slides in snug, then cut the shank to the desired length with a thin dremel blade and your done.

[lektro]

Dog it all the way down then Learn throttle control. I do that with both my p4de and rustler. OH I just saw the eliminator...............Sweetness!