Results 121 to 126 of 126
-
10-13-2019, 12:05 PM #121RC Champion
- Join Date
- Sep 2015
- Location
- S.E. Michigan
- Posts
- 1,112
It does replace the aluminum one and isn't used with the center diff.
Last edited by zedorda; 10-13-2019 at 12:08 PM.
-
10-13-2019, 12:14 PM #122RC Qualifier
- Join Date
- Aug 2017
- Posts
- 278
Good to know! I’m going to rebuild the slipper clutch for a back up or when I want to be wheelie happy.
Originally Posted by zedorda
It does replace the aluminum one and isn't used with the center diff.
Sent from my iPhone using Tapatalk
-
10-13-2019, 12:19 PM #123RC Qualifier
- Join Date
- Aug 2017
- Posts
- 278
Speaking of slipper clutch throwout bearing seized up
Not sure if it was dirt or if it just overheated and expanded
Sent from my iPhone using Tapatalk
-
10-13-2019, 02:22 PM #124RC Qualifier
- Join Date
- Aug 2017
- Posts
- 278
Wrong picture?
Got the rear end almost stripped down and cleaned. Bagging the different parts with their screws.
Disassembling the MiP rear axles was no fun lol. Lots of sand. I like the simplicity of the Teknos I have on front. Looks like this will be a nice fall project. I may be avoiding sandy beaches from now on. Lol
-
10-13-2019, 04:13 PM #125RC Champion
- Join Date
- Sep 2015
- Location
- S.E. Michigan
- Posts
- 1,112
Sand is an evil mistress to RCs.
-
10-13-2019, 04:19 PM #126RC Qualifier
- Join Date
- Aug 2017
- Posts
- 278
Sure is! All the bearings so far in the rear hub carrier and diff need replaced. The ones in the hubs I did last winter I think. Diffs.. they’re the originals and the truck will be 3 next May. Oops. Lol Originally Posted by zedorda
I won’t be playing in sand again until it’s time for a strip down. Sheesh.
Time to pick out some some bearings and seals.
Sent from my iPhone using Tapatalk
Reply With Quote