17 mm hubs pins don't fit ?

[Exiwolfman]

Got me a set of hubs but pins that come with it don't fit my telluride , they are slightly to large anyone had any luck or mod to fit , should I drill the axle pin hole ? Or are they only good for like a Summit or ERevo ?
Any idea ?

Sent from my ONEPLUS A5000 using Tapatalk

[nixhex32]

Those are for the big trucks like the emaxx or revo. You should have gotten 6856x.

[Exiwolfman]

Those are for the big trucks like the emaxx or revo. You should have gotten 6856x.

Ok thanks

Sent from my ONEPLUS A5000 using Tapatalk

[joe419]

Those are for the big trucks like the emaxx or revo. You should have gotten 6856x.

Do you know if the 6856x kit will work with the MIP axles?

[nixhex32]

Do you know if the 6856x kit will work with the MIP axles?

No idea, best bet is to call MIP and see what they say.

[degake]

Do you know if the 6856x kit will work with the MIP axles?

No, the 6858x kit won't work with MIP axles.
Traxxas stock/cvd axles use a axle pin (12mm hexes, with the 17mm hexes this is a screw) to hold the hexes onto the axles.
MIP uses keyed axles, without a hole to put the axle pin through. (the older version MIP axles did, but this turned out to be a weak spot on the axles, so the current design has omitted the holes, in favor of a keyed design).

You can use MIP 10115 17mm hex adapters or Hot-Racing SLF17R06 serrated 17mm hex adapters

[joe419]

No, the 6858x kit won't work with MIP axles.
Traxxas stock/cvd axles use a axle pin (12mm hexes, with the 17mm hexes this is a screw) to hold the hexes onto the axles.
MIP uses keyed axles, without a hole to put the axle pin through. (the older version MIP axles did, but this turned out to be a weak spot on the axles, so the current design has omitted the holes, in favor of a keyed design).

You can use MIP 10115 17mm hex adapters or Hot-Racing SLF17R06 serrated 17mm hex adapters

Thanks for the useful info

Sent from my SM-G930P using Tapatalk

[Miltdoggie]

Hot racing WH17HT01 is what you want. They sit on top of the mip 12mm hex.



Here is a pic, I know its a slash but I do use the adapters I mentioned.

[joe419]

Hot racing WH17HT01 is what you want. They sit on top of the mip 12mm hex.



Here is a pic, I know its a slash but I do use the adapters I mentioned.

So does this change the offset of the wheels at all?

*EDIT

I see on their specs it adds 10mm if anyone else is curious.

Sent from my SM-G930P using Tapatalk

[jimbo74]

it will add width to your setup, but whatever ofset you have on your wheels is on your wheels

I have the +6mm version the HR setup is sweet. I run the MIPs with the keyed 12mm hexes and use the 17mm conversion on my slash lcg 4x4