Results 1 to 6 of 6
  1. #1
    RC poster
    Join Date
    Aug 2009
    Location
    Quebec
    Posts
    17

    Tsm glitch after slow rollover

    Hi,

    This just happened 30 min ago, I just did a very slow roll over and when the truck was upside down TSM glitched and steering went FULL to the right.

    Now TSM thinks that the steering center is full to the right.

    I turned, off turned back on, controller reset etc everything off and on multiple time and no matter what each time i turn that truck on steering goes FULL RIGHT....

    Is there a way to reprogram TSM.... thanks.
    Villain EX
    Yellow Summit
    Onyx 240

  2. #2
    RC Racer
    Join Date
    Dec 2017
    Posts
    165
    Maybe pop open the receiver box and make sure it didn’t come loose and flip sideways during the rollover.

  3. #3
    RC poster
    Join Date
    Aug 2009
    Location
    Quebec
    Posts
    17
    everything is there so i just have to remove steering servo unscrew the arm reposition in center then rescrew...
    How stupid is this why would i have to do that....
    Villain EX
    Yellow Summit
    Onyx 240

  4. #4
    RC poster
    Join Date
    Aug 2009
    Location
    Quebec
    Posts
    17
    it did it again, i went in a steep incline and it started going full right again and stays there at steering neutral....
    Villain EX
    Yellow Summit
    Onyx 240

  5. #5
    RC poster
    Join Date
    Aug 2009
    Location
    Quebec
    Posts
    17
    Found it, its the plastic servo arm internal tooth that are worn and under medium load it was jumping tooth.... so upon returning to center, the arm shifted..... ah well!
    Villain EX
    Yellow Summit
    Onyx 240

  6. #6
    RC Racer
    Join Date
    Dec 2017
    Posts
    165
    Traxxas makes a metal horn. With the upgrade for sure.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •