How do you set the Stock ESC to LVC cutoff

[grave75]

Hi Guys... I have a question does the M-41 have a LVC cutoff set right from TRAXXAS or does it need to be set manually
I replaced 2 sets ( 4 ) Duratraxx 6400Mah 3 cell LIPOS already Duratraxx replaced 1 pack for me under warranty.
what I find odd is I am only Puffing 1 pack out of the two when I run my M-41. The boat is totally stock other than a Hot Body Racing Motor Sleeve


DuraTraxx Tech Support told me I am over discharging the packs but I don't know how since I am only puffing 1 of the 2 packs in the boat. I always balance charge my packs & I have a voltage tester so I always make sure I have 3 good cells before running.


Any help on this matter would be a big help thanks

[Edgemoulic]

Once you plug your batteries, check the esc led if it’s red the LVC is off, if it’s green LVC is on, hope this helps

[Rain Dawg]

Hi Guys... I have a question does the M-41 have a LVC cutoff set right from TRAXXAS or does it need to be set manually
I replaced 2 sets ( 4 ) Duratraxx 6400Mah 3 cell LIPOS already Duratraxx replaced 1 pack for me under warranty.
what I find odd is I am only Puffing 1 pack out of the two when I run my M-41. The boat is totally stock other than a Hot Body Racing Motor Sleeve


DuraTraxx Tech Support told me I am over discharging the packs but I don't know how since I am only puffing 1 of the 2 packs in the boat. I always balance charge my packs & I have a voltage tester so I always make sure I have 3 good cells before running.


Any help on this matter would be a big help thanks

My VXL-6S stock was set at 3.2v per cell, but if you have the Castle link you can bump it up to 3.5v per cell and If you don't have the telemetry package I highly recommend it.
I set my alarms to go off at 3.6 v per cell and it helps from over discharging.
One side always discharges slightly more then the other and I believe that happens on the bec side.
Hope this helps