Results 1 to 3 of 3
  1. #1
    RC Enthusiast
    Join Date
    Dec 2018
    Posts
    26

    anyone ever measure the OD between the slash and ox-1 steering blocks?

    Just thinking out loud here.... building a slash from the ground up and will be looking to use the xo-1 6mm front axles. I like the red anodized aluminum steering blocks available for the slash (5mm). I was wondering if the slash and xo-1 steering blocks are the same except for the 6x12x4 bearing ID hole on the xo-1 steering block is machined 1mm larger with the OD of that hole being the same as the slash block? or if its a completely different part.

    basically im wondering if anyone has measured and compared the wall thickness of each?

    When i have time im going to pull my sons slash platinum front block off and see if there is enough material there to buy a set of red slash steering blocks and cnc them a mm larger.

  2. #2
    RC Enthusiast
    Join Date
    Dec 2018
    Posts
    26
    Ended up just going blue. Got my XO-1 front end parts tonight and started my build finally

  3. #3
    RC Qualifier
    Join Date
    Mar 2013
    Location
    SoCal.
    Posts
    752
    A little late but I have, I have 3 slash trucks using xo-1 steering blocks and axle carriers with 5mm ID bearings for MIP xduty axles.
    IG: @818sFastestRC
    Slash 4x4 138MPH

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •