Results 1 to 2 of 2
  1. #1
    RC poster
    Join Date
    Jan 2019
    Posts
    10

    Disk Break Issues

    I pulled the new model out of the box and started following the new break in procedures. During the running, I wasn't using the brake, just letting off the gas for the slow down. Before the the first tank was gone the car just stopped, engine running. When I pulled off the body the disk was melted in place. I picked up a factory replacement but I haven't run it yet. The break appears to be adjusted properly but I'm not really sure. Also, should I replace the disk with an aftermarket version? Or is the factory brake OK. I'm just running around the house, not actually racing. In case you haven't already guessed, this is my first nitro.

  2. #2
    RC poster
    Join Date
    May 2019
    Posts
    6
    Any luck getting your brake repaired?
    It seems like it had to have been adjusted wrong from the factory, that should not have happened, especially if you were not using the brakes.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •