Hi guys,

I recently bought a used 1/16 erevo used (first RC). Everything worked fine until I broke a servo (stripped some teeth off it). I used it for about 5 more minutes but then my radio kept disconnecting. I recharged the battery and put in a new servo but when I try to turn on the transmitter and truck I get no connection.

The esc is solid red as it should be. The receiver is blinking red (approximately .5 sec per pulse). The transmitter is blinking green extremely fast. This is the tq receiver with only the trim dial. I have reset the esc already but cannot get the tx/rx tobind again, the transmitter stays in bond mode for a bit before going to flashing green.

Anyone have any thoughts? Is my transmitter just dead?

Thanks.