Results 1 to 8 of 8
  1. #1
    RC Qualifier
    Join Date
    Nov 2015
    Posts
    597

    Widening the X Maxx

    Hello, I run Badlands MX43's on the Proline wheels, but would like to increase the width of my X-Maxx, does anyone know of any axle extenders? I've saw these but dont know if theyre any wider?

    https://www.ebay.co.uk/itm/1-5-2PCS-...r=413549795923

    Thanks

  2. #2
    RC Turnbuckle Jr. ReglarGuy's Avatar
    Join Date
    Feb 2012
    Location
    Eastern Shore, Maryland
    Posts
    3,867
    I personally don't know of anything.
    The ReglarGuy is kid tested and father approved.

  3. #3
    RC Racer
    Join Date
    Aug 2017
    Posts
    247
    I donít know of any kit to make the x maxx why wider. Also those just replace the plastic ones one the truck there not any wider.


    Sent from my iPhone using Tapatalk

  4. #4
    RC Qualifier
    Join Date
    Nov 2015
    Posts
    597
    Quote Originally Posted by Nightflier x4.6 View Post
    I don’t know of any kit to make the x maxx why wider. Also those just replace the plastic ones one the truck there not any wider.


    Sent from my iPhone using Tapatalk
    The ones in the link are 13mm and stock are 10mm so technically they would increase width by 6mm total, but not sure if the wheel nuts will hold on enough?

  5. #5
    RC Racer
    Join Date
    Aug 2017
    Posts
    247
    Yes that might be a problem.


    Sent from my iPhone using Tapatalk

  6. #6
    RC Champion nickruger's Avatar
    Join Date
    Jun 2017
    Location
    Ohio
    Posts
    1,162
    Measure how much stub axle you have on the outside of the wheel nut, if it's any more than 3 full mm you should be good to go. If you don't have a caliper I can measure it for you in a bit. I looked this morning for extensions, I know a friend of a friend has a set on one of his speed run xmaxx. I'll see if I can get ahold of him.

    Sent from my SM-N960U using Tapatalk

  7. #7
    RC Champion nickruger's Avatar
    Join Date
    Jun 2017
    Location
    Ohio
    Posts
    1,162
    I took a look at mine, there is only 1.7mm of stub axle left on the outside of the wheel nut, only 2 threads for about 1mm of it, so probably not going to work with the badlands.

    Sent from my SM-N960U using Tapatalk

  8. #8
    RC Qualifier
    Join Date
    Nov 2015
    Posts
    597
    Quote Originally Posted by nickruger View Post
    I took a look at mine, there is only 1.7mm of stub axle left on the outside of the wheel nut, only 2 threads for about 1mm of it, so probably not going to work with the badlands.

    Sent from my SM-N960U using Tapatalk
    Wasnt worth the hassle for 3mm anyway, but thank you for checking

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •