Hey guys, old 6s x-Maxx owner, picked u[ a used 8s x-Maxx. I took the truck apart to inspect and clean everything. When I put it all back together I removed the telemetry wires that went from the receiver to the motor(temp sensor). Now when I plug in my batts ant turn on the esc thereís no green light on the esc and the receiver light blinks fast red. Manual says fast red on the receiver means low voltage. Did I mess up by removing the telemetry wires from the receiver? They didnít seem like they were necessary since the only wire that went anywhere was the motor temp wire. I donít get why the receiver light is doing the fast blink thing.