Steering servo for the MB

[LimitedHansen]

Need a new servo for the Monster buggy. What do you guys have? i can't find a single servo that has the dimensions as the last one. I need some suggestions what to get.

[Rain Dawg]

It would help to know the dimensions of the opening that the servo goes into in milimeters and what your last servo was and either the rc it's going into or at least the scale and how many OZ. of torque your looking for and was your last one capable of what your needs were or was it lagging.

[LimitedHansen]

This is the servo that i need to replace, also those are the dimensions the cutout fits. Link

[Rain Dawg]

This is the servo that i need to replace, also those are the dimensions the cutout fits. Link

It's going to take some searching to find one with those dimensions or just replace it with the same. Here's one with double the torque but smaller dimensions that you could make work.
https://www.savoxusa.com/collections...-black-edition

[LimitedHansen]

Sorry didn't see your post until now. Ordered a new Hitec.
I'll let you know if it's any good. :-)

[Rain Dawg]

Sorry didn't see your post until now. Ordered a new Hitec.
I'll let you know if it's any good. :-)

Specs look good more then the first one you had. I run 2 of these in my Emaxx set at 6v with 8 inch Jumbo Kongs, I'm a big fan of the Hitec servo's.
https://hitecrcd.com/products/servos...d955tw/product

[danielhr77]

Futaba S134 is the way to go.

[ngarry243]

Futaba S134 is the way to go.

I agree, this is the most suitable set for this situation. And the price is great, as far as I remember, about $8-10.