Results 1 to 2 of 2
  1. #1
    RC Champion olds97_lss's Avatar
    Join Date
    Dec 2003
    Location
    Dekalb, IL
    Posts
    2,351

    traxxas 5632 rear chassis brace fit a 3.3 nitro revo?

    I didn't even think about it... have one in coming in the mail for my nitro revo instead of using a turnbuckle like I'm currently using. I was using a turnbuckle on my ERBEv1 but when I transferred it over with some of my other parts to the 2.0 roller, I stripped the rod ends the first time out. I replaced it with the 5632 brace vs the 2.0 plastic one.

    I like having it on my nitro revo's because it gives the pipe something to rest on and it helps support the wing/body mount so it's not ripping the screws out all the time and causing the pipe to flounder/tear up seals.

    Guess it doesn't matter as I'll find out in a couple days.
    Expert rigging at it's best!

  2. #2
    RC Champion olds97_lss's Avatar
    Join Date
    Dec 2003
    Location
    Dekalb, IL
    Posts
    2,351
    For those hanging on the edge of their seats...

    It fits. lol!

    I had to put a notch in it to fit around the Integy engine cage, but otherwise, it bolted right up. It did raise my pipe up a bit and it rests on it. May get another for my big block revo just so I have it on all 3.



    Expert rigging at it's best!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •