Results 1 to 4 of 4
  1. #1
    RC Competitor
    Join Date
    Oct 2018
    Location
    Texas, by God!
    Posts
    59

    Suggestions for strengthening the front of the 1/16 chassis?

    I have a 1/16 Ken Block Rally that I've completely rebuilt into a VXL-3S powered terror. The only problem is, I've hit a curb a couple times, and broken the front of the chassis off. Are there any suggestions to strengthen the front of the chassis? I see lots of suggestions for the back end, but nothing for the nose.

    A little help here?

    Thanks,

    Da Beav
    I find your lack of teepee disturbing.

  2. #2
    RC Qualifier
    Join Date
    Dec 2016
    Location
    N Dakota USA
    Posts
    660
    I know T bone racing makes a lot of various chassis beef up parts

  3. #3
    RC Qualifier
    Join Date
    Dec 2014
    Location
    Adirondacks
    Posts
    571
    Lots of good reviews on the T-Bone plates holding these chassis's together.

  4. #4
    RC Competitor
    Join Date
    Oct 2018
    Location
    Texas, by God!
    Posts
    59
    I'll have to check T-Bone out. I'm just concerned that it will be dragging the ground.

    On the flip side, better than swapping chassis AGAIN.
    I find your lack of teepee disturbing.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •