Results 1 to 5 of 5
  1. #1
    RC Qualifier
    Join Date
    Sep 2012
    Location
    Hammonton Nj
    Posts
    841

    Hinge pins- mod - 1/8 titanium drill bits

    I found a cheap but affective way for better a arm pins
    Buy 1/8 long drill bits and cut them with a dremmel tool , to length
    Then just put a little shoe goo on the ends to keep them in place.
    Much cheaper than the strc ones
    And you can even buy titanium ones cheap




    Sent from my iPad using Tapatalk

    its hard to see, just a little shoe goo over the pin
    Last edited by cooleocool; 03-14-2020 at 01:59 AM. Reason: merge

  2. #2
    RC Qualifier Rocketzx1's Avatar
    Join Date
    Oct 2018
    Location
    Tennessee
    Posts
    469
    Sounds great! But how would you ever get them out if you ever needed to remove them?


    Sent from my iPhone using Tapatalk

  3. #3
    RC Qualifier
    Join Date
    Sep 2012
    Location
    Hammonton Nj
    Posts
    841
    Easy , it just peels off

  4. #4
    RC Competitor
    Join Date
    Apr 2012
    Location
    Space Coast, Florida
    Posts
    91
    I wonder if you could notch them slightly near the ends to provide a place to use C clips to hold them in. I would be afraid of the pin working it's way loose, even with the shoe goo in there, especially if you can just peel it off.

  5. #5
    RC Qualifier
    Join Date
    Sep 2012
    Location
    Hammonton Nj
    Posts
    841
    I have done this for a few years , never had one fall out , not sure if i could notch them straight

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •