Results 1 to 4 of 4
  1. #1
    RC poster
    Join Date
    Mar 2020
    Posts
    2

    Engine/transmission clearance.

    Hey all. Was wonder if someone could help. I want to move either the engine back or the trans forward. I am having two issues. It is tight to get the air cleaner on and the spur and bell clutch gear aren't meshing well. Any help would be great.

    Thanks

  2. #2
    Marshal Double G's Avatar
    Join Date
    May 2008
    Posts
    13,893
    Are you running stock engine and transmission? The flywheel, clutch and clutch bell correctly installed? The spur gear installed correctly? Check the chassis under the engine - it has been reported that it can bend in a hard crash and cause issues. A new chassis can be had for pretty cheap.
    The Super Derecho

  3. #3
    RC Champion olds97_lss's Avatar
    Join Date
    Dec 2003
    Location
    Dekalb, IL
    Posts
    2,852
    Also, what gearing are you running? Spur/cb? Are you running the traxxas carb and traxxas high flow filter or the smaller one? I thin they both had the same carb neck.

    I know if your geared really low (large spur/small bell), the carb rests down low behind the spur a bit and it's a pain.
    Expert rigging at it's best!

  4. #4
    RC poster
    Join Date
    Mar 2020
    Posts
    2
    Thanks for the ideas. Everything is stock on. I'll look into the chassis. Thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •