Results 1 to 3 of 3
-
08-31-2020, 12:03 PM #1RC Racer
- Join Date
- Mar 2020
- Location
- NE Wisconsin
- Posts
- 140
Mounting plates needed for 3.3 Nitro Sport?
So, after over 10 years of use, my mounting plates for my pro .15 (got that stupid thing running again
, all of its problems were being caused by a bad fuel tank spring and exhaust header) are rather worn, one of the screw holes are stripped, etc. My question is, do I need the old mounting plates when I upgrade to a 3.3 engine? I just ordered #4400 but it hasn't arrived yet, and if I need the mounts I would like to get them as soon as possible.The 2 brackets shown in the picture are what I am talking about in this. Thanks a lot.
I'm not afraid of my fellow man.
-
08-31-2020, 12:08 PM #2RC Champion
- Join Date
- Dec 2014
- Location
- Adirondacks
- Posts
- 2,472
Hope this helps you.
Traxxas part #4400 upgrade kit: https://traxxas.com/products/parts/4400
Part #4400 instructions:https://traxxas.com/sites/default/fi...5Convkit_1.pdf
-
11-26-2020, 02:53 AM #3RC poster
- Join Date
- Sep 2020
- Posts
- 2
Please excuse me for a simple question. But is it possible to make such plates on a 3D printer?
Reply With Quote
